Cisco Cisco Catalyst 6500 Series Firewall Services Module Guía Para Resolver Problemas

Error executing command

[FAILED]

In this case, the configuration file for the context in might be corrupted. Complete these steps in order to
troubleshoot the issue:

Enter the fsck command in order to check the consistency of the file system. The term fsck is an
acronym for filesystem check. This utility usually runs automatically at device startup and checks for
anomalies within the filesystem in case of abnormal events. It fixes the problem within the filesystem
and saves it as a recovery file. Enter the fsck disk: command in order to execute the fsck utility. After
you enter the fsck command, try to save the configuration again. If this fails, proceed to Step 2.

1. 

Change the URL for the context to another name and then execute the write mem command in that
context.

FWSM(config−context)#config−url disk:/context−A−new.cfg

Note: This is a temporarily solution.

You must be in the system context under the context configuration section in order to change the
configuration URL for a context. If this step does not resolve the issue, proceed to Step 3.

2. 

Format the Flash from the system context.

FWSM# format disk:

Format operation may take a while. Continue? [confirm]

Format operation will destroy all data in "disk:".  Continue? [confirm]

Format: All system sectors written. OK...

Format: Total sectors in formatted partition: 116704

Format: Total bytes in formatted partition: 59752448

Format: Operation completed successfully.

Format of disk complete

FWSM#

Caution: This action removes all configurations from the flash. You must then execute the write
memory all command in order to resave all FWSM context configurations.

3. 

Updated: Jun 30, 2014

Document ID: 117815