Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guía De Instalación

Leave the BLSR in the lockout state until you have finished activating all nodes.

A Default K alarm or alarms on the protect STS timeslots can occur during this lockout period. Ignore 
these alarms if they occur.

Perform the following steps for all nodes in the network. 

Make sure all cards that are part of a protection group (1:1 and 1:N) are active on the working card of 
that protection group and that no protection switches are occurring.  In other words, make sure protect 
cards are in standby before proceeding.

To ensure database synchronization, run the memAudit utility:

Close all active telnet connections to the ONS 15454.

Copy the memAudit.exe from the ONS 15454 software CD or the following Cisco.com web page to 
a folder on your hard drive: 

http://www.cisco.com/cgi-bin/tablebuild.pl/ons15454

In a command window, change the prompt to the folder where the memAudit.exe is located. 

At the prompt, type the following command:

Optional parameters exist for the memAudit command. For more information about the 
memAudit utility, view the memAudit_readme.htm file on the CD or Cisco.com web page.

Log into and activate each node in the network. 

Upon activation, you may receive a series of Java exception errors. Please disregard these messages as 
they are due to the changes instituted in the Java code base for 3.0.0 that 2.2.x is unable to interpret. The 
Java exceptions have no adverse effect.

Log into a node.

Record the IP address of that node.

Verify that the node has no new alarms. If alarms exist, clear them before proceeding.

From the CTC node view, click the Maintenance > Software tabs.

Verify that the protect version is 3.0.0.

Click Activate. The Activate dialog box appears with a warning message.