Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Guía Para Resolver Problemas
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Network Diagram
This document uses a lab setup with two ONS 15454 nodes and two Catalyst 3500 XL switches. EachONS
15454 is equipped with one ML 1000−2 card, and a Resilient Packet Ring (RPR) is built between them across
the ML 1000−2 card. Two Gigabit Ethernet ports on Catalyst 3500 XL are connected to two Gigabit Ethernet
ports on the ML 1000−2 card respectively. The network diagram is displayed in Figure 1.
15454 is equipped with one ML 1000−2 card, and a Resilient Packet Ring (RPR) is built between them across
the ML 1000−2 card. Two Gigabit Ethernet ports on Catalyst 3500 XL are connected to two Gigabit Ethernet
ports on the ML 1000−2 card respectively. The network diagram is displayed in Figure 1.
Figure 1: Network Diagram
Configuration
Configuring RPR
Complete these steps to build RPR:
Create a circuit between POS 0 of ML1000−2 on ONS 15454 A and POS 1 of ML1000−2 on ONS
15454 B.
15454 B.
1.
Create a circuit between POS 1 of ML1000−2 on ONS 15454 A and POS 0 of ML1000−2 on ONS
15454 B.
15454 B.
2.
Configure ML1000−2 card on ONS 15454 A.
Turn on Integrated Bridging and Routing (IRB).
bridge irb
a.
Create bridge 1
Bridge 1 protocol rstp
b.
Configure the SRP interface.
interface SPR1
no ip address
no keepalive
spr station−id 3
spr topology discovery
c.
3.