Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Notas de publicación

The PROV-MISMATCH alarm is raised on TXP-MR-10E cards when a port with an ONS-XC-10G-L2 
pluggable port module (PPM) is provisioned for ZR reach for 10GE. This issue will be resolved in a 
future release.

The trunk port of the Y-cable protected TXP-MR-2.5G card raises an LOS-P alarm when the port is in 
Critical state. The workaround is to change the port status to OOS,DSBLD, which causes the LOS-P 
alarm to downgrade from Critical state to Minor. This issue will be resolved in a future release.

Transient alarms occur under the following conditions:

When upgrading the software from Cisco ONS Release 4.x, 5.x, 6.x, and 7.x to Cisco ONS 
Release 8.5, the PMI and FDI alarms are raised. These alarms disappear after all the nodes of the 
network are upgraded to Cisco ONS Release 8.5.

When upgrading the software from Cisco ONS Release 8.0 to Cisco ONS Release 8.5, the PMI, FDI 
and APC-CORR-SKIP alarms are raised. These alarms disappear after all the nodes of the network 
are upgraded to Cisco ONS Release 8.5.

This issue will be resolved in a future release.

The OPWR_LFAIL and OPWR_HFAIL alarms do not properly correlate the downstream alarms when 
MPO connected to the ADD port is removed from the ADD circuit passing through WXC card. This 
issue will be resolved in a future release.

A SYNCLOSS alarm is raised for a long time on a Y-cable switch when switching back to a working 
card after an WTR alarm is cleared for MXP-MR-10DME cards. This issue will be resolved in a future 
release.

An LOS-P alarm is reported in Critical severity on Y-cable protected MXP-MR-10DME card even when 
it is in standby mode. This issue will be resolved in a future release.