Cisco Cisco Web Security Appliance S360 Guía De Información
Content Security Appliances FAQ: How do you
perform a packet capture on a Cisco Content
Security appliance?
perform a packet capture on a Cisco Content
Security appliance?
Document ID: 117843
Contributed by Khoa Nguyen and Robert Sherwin, Cisco TAC
Engineers.
Jun 25, 2014
Engineers.
Jun 25, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
How do you perform a packet capture on a Cisco Content Security appliance?
Prerequisites
Requirements
Components Used
How do you perform a packet capture on a Cisco Content Security appliance?
Introduction
This document describes how to perform packet captures on the Cisco Content Security appliances.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco Email Security Appliance (ESA)
•
Cisco Web Security Appliance (WSA)
•
Cisco Security Management Appliance (SMA)
•
AsyncOS
•
Components Used
The information in this document is base on all versions of AsyncOS.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
How do you perform a packet capture on a Cisco Content
Security appliance?
Security appliance?
Complete these steps in order to perform a packet capture (tcpdump command) with the GUI:
Navigate to Help and Support > Packet Capture on the GUI.
1.