Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Notas de publicación

The following items are resolved in Release 4.1.2

Rarely, an E1-42 card can go into continual autoreset. This can occur after the E1-42 card is inserted, or 
following a node power cycle. Hard reset the E1-42 by removing and re-inserting it into the chassis to 
stop this cycle. This issue is resolved in a Release 4.1.2.

Rarely, a greater than 2 second traffic hit can occur when the active XC is pulled, then you switch the IO 
from active (Working) to standby (protect). This issue is resolved in Release 4.1.2.

Occasionally, if you remove the active working E1-42 card, the card takes a greater than 60 ms hit. This 
issue is resolved in Release 4.1.2. 

On an E1-42, the LOSS-L parameter appears as random values. For example, sometimes it appears as 
-269,488,145. This makes the count unavailable from the card. This issue is resolved in Releases 4.6 and 
4.1.2.

If you configure 1:N or 1:1 protection for DS1, DS3, E1, or E3, then lock the XC and soft reset the active 
XC, after the XC finishes resetting, the protection for the electrical cards switches. This issue is resolved 
in Releases 4.1.2 and 4.6.

If you configure Fast EtherChannel and POS-channel in the same bridge group, during system boot, the 
Fast EtherChannel or POS-channel configuration may be lost and following error message displayed:

Interface FastEthernet1 is attempting to join Port-channel1. But Port-channel1 

belongs to bridge-group 1 which has another FE(C) member in it. FEC + FE(C) is not 

allowed in the same bridge group. Please change your configuration and retry.

This issue is resolved in Release 4.1.