Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Notas de publicación

Active cross connect cards should not be removed. If the active cross connect or TCCi/2 card must be 
removed, to minimize network interruption you can first perform an XC10G (or XCVXL) side switch 
and then remove the card once it is in standby, or you can perform a lockout on all circuits that originate 
from the node whose active cross connect or active TCCi/2 will be removed (performing a lockout on all 
spans will also accomplish the same goal). No lockout is necessary for switches initiated through CTC. 

In the CTC Performance > Statistics tab of the G1000-4 or G1000-2, there are no entries for Rx/Tx 
Multicast and Broadcast packets. This issue is resolved in Release 4.6.

The following two notes on page 5-30 of the Cisco ONS 15454 Reference Manual, R4.1 and R4.5 should 
be replaced.

G-Series cards manufactured before August 2003 do not support DWDM GBICs. G1000-4 cards 
compatible with DWDM GBICs have a CLEI code of SNP8KW0KAB. Compatible G1K-4 cards 
have a CLEI code of WM5IRWPCAA.

All versions of G1000-4 and G1K-4 cards support CWDM GBICs.

The replacement information is contained in 

The following items are resolved in Release 4.1.8

Malformed IP packets can potentially cause the XTC, TCC/TCC+/TCC2 and TCCi/TCC2 control cards 
to reset. Repeated transmission of these malformed packets could cause both the control cards to reset 
at the same time. This issue is resolved in Release 5.0, and maintenance Releases 4.1.4, 2.3.5, 4.0.3, and 
4.6.2.