Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Notas de publicación

The Link Integrity Soak Timer enhancement allows you to configure link integrity soak timer on per port 
basis. To allow link integrity to be initiated at an interval greater than 200 ms, set the link integrity timer 
in the range between 200 ms and 10000 ms, in multiples of 100 ms.

The Link Integrity Disable enhancement allows you to disable Link Integrity Soak Timer functionality 
on a per port basis.

When the link integrity timer value on CE-1000-4 card with VCAT circuit is more than 1400 ms, the 
transition from IS > OOS > IS causes a delay of 1100 ms.

The Cisco ONS 15454 Software Release 8.5.4 increases the maximum number of ENE sessions over a 
OSI DCC from 20 to 176. If you use a combination of IP ENE and OSI ENE sessions, it is important to 
remember that the maximum number of ENEs supported per GNE is equal to the maximum number of 
IP ENEs.

This section lists release-specific and platform-specific documents.

Cisco ONS 15454 SDH Procedure Guide
Provides installation, turn up, test, and maintenance procedures

Cisco ONS 15454 SDH Reference Manual
Provides technical reference information for SONET/SDH cards, nodes, and networks

Cisco ONS 15454 DWDM Installation and Operations Guide
Provides technical reference information for DWDM cards, nodes, and networks

Cisco ONS 15454 SDH Troubleshooting Guide
Provides a list of SDH alarms and troubleshooting procedures, general troubleshooting information, 
transient conditions, and error messages

Cisco ONS SDH TL1 Command Guide
Provides a comprehensive list of TL1 commands

Cisco ONS SDH TL1 Reference Guide
Provides general information, procedures, and errors for TL1