Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guía De Instalación
15
Installing and Operating UBIC-V EIAs in the Cisco ONS 15454
78-16140-04
Install UBIC-V EIA Cables
Figure 11
Tie-Down Bar
Step 2
Install the two screws into the rack.
Install UBIC-V EIA Cables
You will need the following equipment to install the DS-1 and DS-3/EC-1 cables on the UBIC-V EIA:
•
3/16-inch flathead screwdriver
•
DS-1 and DS-3/EC-1 cables, as needed:
–
DS-1 cable, 150 feet: 15454-CADS1-SD
–
DS-1 cable, 250 feet: 15454-CADS1-ID
–
DS-1 cable, 655 feet: 15454-CADS1-LD
–
DS-3/EC-1 cable, 75 feet: 15454-CADS3-SD
–
DS-3/EC-1 cable, 225 feet: 15454-CADS3-ID
–
DS-3/EC-1 cable, 450 feet: 15454-CADS3-LD
Note
Cisco recommends that you plan for future slot utilization and fully cable all SCSI connectors you will
use later.
use later.
Step 1
Starting at the lowest row where you want to install cables, place a cable connector over the desired
connection point on the backplane.
connection point on the backplane.
Step 2
Carefully push the connector into the backplane until the notch backplane connector slides into the slot
on the cable connector.
on the cable connector.
105012
Tie-down bar