Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Notas de publicación
5
Release Notes for Cisco ONS 15454 Release 9.0.2
OL-21473-01
Changes to the Release Notes
Changes to the Release Notes
This section documents supplemental information that has been added to the Release Notes for
Cisco ONS 15454 Release 9.0 since the production of the Cisco ONS 15454 System Software CD for
Release 9.0.
Cisco ONS 15454 Release 9.0 since the production of the Cisco ONS 15454 System Software CD for
Release 9.0.
Caveats
Review the notes listed below before deploying the Cisco ONS 15454. Caveats with tracking numbers
are known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
tracking numbers are provided to point out procedural or situational considerations when deploying the
product.
are known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
tracking numbers are provided to point out procedural or situational considerations when deploying the
product.
Data I/O Cards
This section documents caveats for Data I/O Cards in Release 9.0.2.
CSCsz79019 —GE_XP cards reboot when changing from UNI to NNI mode
GE_XP cards reboot when changing from UNI to NNI mode and when configuring QinQ via TL1. In
addition, any traffic flowing through the card stops and the card gives an equipment failure alarm.
addition, any traffic flowing through the card stops and the card gives an equipment failure alarm.
Change the UNI mode of the port via CTC to NNI and the QinQ mode to Selective.
This issue will be resolved in a future release.
CSCtd48197—Unable to set Egress bandwidth limiting in GE_XPE cards
Traffic flow is observed even when Egress bandwidth limit is set in GE_XPE cards. This issue will be
resolved in a future release.
resolved in a future release.
CSCtd50130—Loop is created when FAPS protection is disabled in fail state and renabled
If FAPS protection is disabled in a fail state (one of the trunk is disabled or any there are other failures)
and again renabled, a loop is formed. This condition occurs if the card is selected as a Master or Slave.
To fix the issue, soft reset the card.
and again renabled, a loop is formed. This condition occurs if the card is selected as a Master or Slave.
To fix the issue, soft reset the card.
This issue will be resolved in a future release.
Resolved Caveats for Release 9.0.2
This section documents caveats resolved in Release 9.0.2.
CTC
This section documents resolved caveats for CTC in Release 9.0.2.