Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Notas de publicación

The following SNMP attributes will be replaced in future releases, and will no longer be supported after 
Release 7.x.

cMsDwdmIfMultiplexSectionRingDirection

cMsDwdmIfTransportRingDirection

cMsDwdmIfChannelRingDirection

To be compatible with TL1 and DNS, all nodes must have valid names. Node names should contain 
alphanumeric characters or hyphens, but no special characters or spaces. 

You cannot perform an ENT-EQPT for a valid card type when the current equipment state is 
OOS-AUMA,MEA&UAS. When the fault PPM comes up as OOS-AUMA,MEA&UAS and then the 
ENT-EQPT command is entered using TL1, the command is rejected. This issue will be resolved in a 
future release.

Using a TL1 script to rapidly preprovision/delete various cards repeatedly in the same slot will reboot 
the TCC approximately 1 out of 10 times. Put a delay of about 10 seconds between 
preprovisioning/deletion cycles and the node will not reboot. This issue will be resolved in a future 
release.

When a TL1 session to a remote node (ENE) is established via a gateway node (GNE) and you have 
changed the node name of the ENE via either TL1, CTC or SNMP, then you must wait for about 30 
seconds to issue a TL1 command via the GNE. This delay is to permit the updates to propagate to all 
nodes in the network. During this transition, neither the old node name nor the new node name can be 
used in the TL1 session to access the ENE. This 30 second window may be reduced in a future release.

This section documents caveats resolved in Release 8.0.