Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Notas de publicación
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
3
Release Notes for Cisco ONS 15454 Release 4.1.8.1
OL-9184-01
Changes to the Release Notes
Changes to the Release Notes
This section documents supplemental changes that have been added to the Release Notes for Cisco ONS
15454 Release 4.1.8.1 since the production of the Cisco ONS 15454 System Software CD for Release
4.1.8.1.
15454 Release 4.1.8.1 since the production of the Cisco ONS 15454 System Software CD for Release
4.1.8.1.
The following changes have been added to the release notes for Release 4.1.8.1.
Changes to Resolved Caveats
The following resolved caveat has been added.
Caveats
Review the notes listed below before deploying the ONS 15454. Caveats with tracking numbers are
known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
tracking numbers are provided to point out procedural or situational considerations when deploying the
product.
known system limitations that are scheduled to be addressed in a subsequent release. Caveats without
tracking numbers are provided to point out procedural or situational considerations when deploying the
product.
Software Upgrades
Path Protection Over 1+1 Provisioning Prior to Upgrade
The value of the NODE.circuits.upsr.AllowUpsrOverOnePlusOne NE default after a software upgrade
is FALSE. To enable Path Protection over 1+1 you must set this default to TRUE in the Defaults editor
window. To edit NE defaults refer to the “NTP-A164 Edit Network Element Defaults” procedure in the
Cisco ONS 15454 Release 4.1 Network Element Defaults document.
is FALSE. To enable Path Protection over 1+1 you must set this default to TRUE in the Defaults editor
window. To edit NE defaults refer to the “NTP-A164 Edit Network Element Defaults” procedure in the
Cisco ONS 15454 Release 4.1 Network Element Defaults document.
Maintenance and Administration
Caution
VxWorks is intended for qualified Cisco personnel only. Customer use of VxWorks is not recommended,
nor is it supported by Cisco's Technical Assistance Center. Inappropriate use of VxWorks commands can
have a negative and service affecting impact on your network. Please consult the troubleshooting guide
for your release and platform for appropriate troubleshooting procedures. To exit without logging in,
enter a Control-D (hold down the Control and D keys at the same time) at the Username prompt. To exit
after logging in, type “logout” at the VxWorks shell prompt.
nor is it supported by Cisco's Technical Assistance Center. Inappropriate use of VxWorks commands can
have a negative and service affecting impact on your network. Please consult the troubleshooting guide
for your release and platform for appropriate troubleshooting procedures. To exit without logging in,
enter a Control-D (hold down the Control and D keys at the same time) at the Username prompt. To exit
after logging in, type “logout” at the VxWorks shell prompt.
Note
CTC does not support adding/creating more than 5 circuits in auto-ranged provisioning. This is as
designed.
designed.