Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guía De Instalación
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2001. Cisco Systems, Inc. All rights reserved.
OL-1649-02
Upgrading Cisco ONS 15454 Release 2.2.x to 3.0.2
Using the TCC+ Card
Using the TCC+ Card
Introduction
This document explains how to upgrade Cisco ONS 15454's Cisco Transport Controller (CTC) software
from Release 2.2.x to Release 3.0.2 using the Timing, Communications, and Control + (TCC+) card.
from Release 2.2.x to Release 3.0.2 using the Timing, Communications, and Control + (TCC+) card.
Before beginning, write down the following information about your site; the data will be useful during
and after the upgrade: Date, Street Address, Site Phone Number, and Dial Up Number.
and after the upgrade: Date, Street Address, Site Phone Number, and Dial Up Number.
Caution
Read each procedure before you begin the upgrade.
Caution
This procedure is only supported for Release 2.2.x. If you wish to upgrade from Releases
3.0 – 3.0.2, use the procedures in Upgrading Cisco ONS 15454 Release 3.0.x to 3.0.2 Using
the TCC+ Card. If you wish to upgrade from a release prior to Release 2.2.0, you must call
the Technical Assistance Center (TAC) at 877 323-7368 for assistance.
3.0 – 3.0.2, use the procedures in Upgrading Cisco ONS 15454 Release 3.0.x to 3.0.2 Using
the TCC+ Card. If you wish to upgrade from a release prior to Release 2.2.0, you must call
the Technical Assistance Center (TAC) at 877 323-7368 for assistance.
Note
Procedures in this document are to be performed in consecutive order unless otherwise
noted. In general, you are not done with a procedure until you have completed it for each
node you are upgrading, and you are not done with the upgrade until you have completed
each procedure that applies to your network. If you are new to upgrading the ONS 15454,
you may wish to check off each procedure on your printed copy of this document as you
complete it.
noted. In general, you are not done with a procedure until you have completed it for each
node you are upgrading, and you are not done with the upgrade until you have completed
each procedure that applies to your network. If you are new to upgrading the ONS 15454,
you may wish to check off each procedure on your printed copy of this document as you
complete it.