Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Referencia técnica
Corporate Headquarters:
Copyright © 2004-2007 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco ONS 15454 Release 4.6 Network Element
Defaults
Defaults
Note
The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This document describes the factory-configured (default) network element (NE) settings for the Cisco
ONS 15454. It includes descriptions of card default settings and node default settings and provides
procedures for importing, exporting and editing the settings. Cards supported by this platform that are
not listed in this document are not supported by factory-configured NE default settings.
ONS 15454. It includes descriptions of card default settings and node default settings and provides
procedures for importing, exporting and editing the settings. Cards supported by this platform that are
not listed in this document are not supported by factory-configured NE default settings.
To change card settings individually (that is, without changing the defaults), refer to the Change Card
Settings chapter of the Cisco ONS 15454 Procedure Guide. To change node settings, refer to the Change
Node Settings chapter of the Cisco ONS 15454 Procedure Guide.
Settings chapter of the Cisco ONS 15454 Procedure Guide. To change node settings, refer to the Change
Node Settings chapter of the Cisco ONS 15454 Procedure Guide.
This document contains the following sections and procedures:
•
•
•
•
•
•
•
•
•
•
•
•