Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) Guía Para Resolver Problemas

Check whether the INVMACADR alarm is still present.
If the INVMACADR was present for both step 4 and step 5, the AIP is probably defective. Proceed to
step 7.

If the INVMACADR was present only in either step 4 or step 5, replace the TCC+/TCC2 that was
active at that time. If the card is currently in standby, you can simply remove and replace the card. If
the card is active, follow the procedure in Reset Active TCC+/TCC2 Card and Activate Standby Card
in order to make the card standby, and then simply remove and replace the card.

Note: If the replacement TCC+/TCC2 is loaded with a software version other than that of the active
TCC+/TCC2, the card can take up to 30 minutes to load. The LEDs flicker between Fail and Act/Stby
while the software is copied from the active TCC+/TCC2.

6. 

Open a case with the Cisco Technical Assistance Center for assistance on how to determine the
previous MAC address of the node. Replace the AIP. To do so, follow the procedure in the Replace
the Alarm Interface Panel section in chapter 3 of the Cisco ONS 15454 Troubleshooting Guide,
Releases 4.1.x and 4.5.

7. 

• 

• 

Contacts & Feedback | Help | Site Map
© 2013 − 2014 Cisco Systems, Inc. All rights reserved. Terms & Conditions | Privacy Statement | Cookie Policy | Trademarks of
Cisco Systems, Inc.

Updated: Feb 03, 2005

Document ID: 46181