Cisco Cisco Unified MeetingPlace Audio Server Manual De Mantenimiento
4-31
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Configuring the system
Remote loopback to
network
network
n
Specifies if the span should
be put into a loopback mode
for testing from the remote
end.
be put into a loopback mode
for testing from the remote
end.
•
y = yes
•
n = no (normal
operation)
operation)
Internal data
loopback
loopback
n
Specifies if the span should
loop back locally for running
diagnostics.
loop back locally for running
diagnostics.
•
y = yes
•
n = no (normal
operation)
operation)
Port group
0
Specifies the number of the
port group.
port group.
•
0 (T1 CAS)
•
1 (IP)
•
2 (E1)
•
3 (T1 PRI)
Active?
y (if you use a
blade to
configure T1)
blade to
configure T1)
Specifies if the port group is
active.
active.
•
y = yes
•
n = no
Card type
T1
Specifies the type of card.
•
none
•
T1
•
analog
•
E1
•
IP
Signaling protocol
wink start
Specifies the signaling
protocol.
protocol.
•
loop start
•
wink start
•
ground start
•
clear channel
•
E1
•
IP
•
protocol table
Protocol table
0
Specifies the number of the
protocol table to copy from.
protocol table to copy from.
•
number from 0 to
99
99
Number of DID
digits expected
digits expected
0
Specifies the number of DID
digits.
digits.
•
number from 0 to
6
6
Table 4-5
Default T1 CAS Span Configuration (continued)
Parameter
Default
Explanation
Possible Values
X