Cisco Cisco D9824 Advanced Multi Decryption Receiver Guía De Instalación
Chapter 5 Web GUI Setup and Monitoring
260
5 The Alarm Setup area displays a list of the alarm/fault messages. For more
information on alarm messages, refer to D9824 Alarm Messages (on page 286).
6 From the Enable/Disable drop-down list, choose Yes to report the alarm
message. Choose No to disable the alarm and the Relay and Trap settings are
ignored.
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
ignored.
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
7 If current alarm is enabled, from the Trap drop-down list, choose Yes to send the
SNMP trap message when the alarm is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
8 If current alarm is enabled, from the Relay drop-down list, choose Yes to trigger
the rear panel alarm when the alarm is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
9 Click Apply.
To Set Up Warnings
1 From the Alarm Setup page, click the Warning Setup link at the bottom left hand
1 From the Alarm Setup page, click the Warning Setup link at the bottom left hand
corner of the page. The Warning Setup page is displayed.
2 Check the Enable Alarm/Warning Front Panel Reminder check box for the
warning to flash on the LCD display for a two-second interval every 10 seconds.
The warning will continue to flash periodically until it is either cleared or the
The warning will continue to flash periodically until it is either cleared or the
Enable Alarm/Warning Front Panel Reminder is de-selected.
3 The Warning Setup area displays a list of the warning messages. For more
information on warning messages, refer to D9824 Alarm Messages (on page 286).
4 From the Enable/Disable drop-down list, choose Yes too report the warning
message. Choose No to disable the warning and the Relay and Trap settings are
ignored.
ignored.