Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
show apn
▀ show apn all
▄ Cisco ASR 5x00 Statistics and Counters Reference
2752
show apn all
Table 187.
show apn all
Command Output Descriptions
Field
Description
access point name (APN)
Indicates the name of the access point name (APN) for which counters are displayed.
authentication context
Name of the system context used for authentication for this APN.
pdp type
Indicates the type of PDP context. Possible types are:
IPv4
IPv6
PPP
ehrpd access
Specifies whether
ehrpd-access
option is configured in this APN or not.
If enabled, the P-GW excludes IPv6 traffic from being delivered to UEs on the eHRPD
network that do not have IPv6 capabilities.
network that do not have IPv6 capabilities.
emergency
Specifies whether
emergency-apn
option is configured in this APN or not.
If enabled, this APN is an emergency APN for VoLTE based E911 support.
Selection Mode
Indicates the APN selection mode applicable for this APN. Possible selection modes are:
Chosen by SGSN
Sent by MS
Subscribed
ip source violation
Indicates whether check for IPv4 source validation violations enabled or not. Possible status
are:
are:
Checked
Ignored
drop limit
Indicates the IP source-violation drop limit configured for the subscriber. The drop-limit is the
number of invalid packets that can be received from a subscriber prior to their session being
deleted. Refer to the
number of invalid packets that can be received from a subscriber prior to their session being
deleted. Refer to the
ip source-violation
command in the APN configuration mode.
ip source violation no
accounting
accounting
The IP source validation violations that were detected but not included in the statistics.
accounting mode
Indicates the accounting mode configured for this APN. Possible modes are:
gtpp - GTPP CDR accounting
none - No accounting
radius-diameter - RADIUS or Diameter accounting
No early PDUs
Specifies whether “
no-early-pdu
” option configured in this APN or not.
If “no-early-PDUs” is enabled, the chassis shall not send uplink/downlink data from/to a MS
till it receives the Acct-Rsp Start for the same from the AAA device. On receiving the
Acct-Rsp, pending PDUs are sent out.
till it receives the Acct-Rsp Start for the same from the AAA device. On receiving the
Acct-Rsp, pending PDUs are sent out.