Cisco Cisco Aironet 350 Workgroup Bridges Notas de publicación

This section describes known issues for firmware version release 8.58 and earlier.

CSCdt50434

If an IP address is statically assigned, DHCP is not automatically disabled when using the web 
interface. With DHCP enabled, the bridge boots using the assigned IP address as expected. However, 
the bridge intermittently loses communication with the access point.  

The association table on the access point shows a question mark (?) beside the IP address of the 
bridge. Eventually, the association table shows the IP address as 0.0.0.0.  

Workaround: Disable DHCP on the bridge.

CSCdr93580

When using SMIC (the compiler Cisco uses to test MIBs), the Cisco Aironet MIB does not compile 
without errors. SMIC displays a message indicating that “0” cannot be used as an enumerated value 
and prevents the MIB from being posted on CCO.

Workaround: The TAC will provide the MIB by email on request.

The following sections explain how to obtain documentation from Cisco Systems.

You can access the most current Cisco documentation on the World Wide Web at the following URL:

Translated documentation is available at the following URL:

Cisco documentation and additional literature are available in a Cisco Documentation CD-ROM 
package, which is shipped with your product. The Documentation CD-ROM is updated monthly and may 
be more current than printed documentation. The CD-ROM package is available as a single unit

 

or 

through an annual subscription.