Cisco Cisco Email Security Appliance X1050 Guía Del Usuario
24-46
Cisco AsyncOS 9.1 for Email User Guide
Chapter 24 Configuring Routing and Delivery Features
Controlling Email Delivery Using Destination Controls
Note
If limits are applied per each Virtual Gateway address, you can still effectively implement system-wide
limits by setting the Virtual Gateway limit to the system-wide limit you want divided by the number of
possible virtual gateways. For example, if you have four Virtual Gateway addresses configured, and you
do not want to open more than 100 simultaneous connections to the domain
limits by setting the Virtual Gateway limit to the system-wide limit you want divided by the number of
possible virtual gateways. For example, if you have four Virtual Gateway addresses configured, and you
do not want to open more than 100 simultaneous connections to the domain
yahoo.com
, set the Virtual
Gateway limit to 25 simultaneous connections.
Note
The
delivernow
command, when acting on all domains, resets all counters tracked in the
destconfig
command.
Controlling TLS
You can also configure the TLS (Transport Layer Security) on a per-domain basis. If the “Required”
setting is specified, a TLS connection will be negotiated from the appliance listener to MTA(s) for the
domain. If the negotiation fails, no email will be sent through the connection. For more information, see
setting is specified, a TLS connection will be negotiated from the appliance listener to MTA(s) for the
domain. If the negotiation fails, no email will be sent through the connection. For more information, see
.
You can specify whether the appliance sends an alert if the TLS negotiation fails when delivering
messages to a domain that requires a TLS connection. The alert message contains name of the destination
domain for the failed TLS negotiation. The appliance sends the alert message to all recipients set to
receive Warning severity level alerts for System alert types. You can manage alert recipients via the
System Administration > Alerts page in the GUI (or via the
messages to a domain that requires a TLS connection. The alert message contains name of the destination
domain for the failed TLS negotiation. The appliance sends the alert message to all recipients set to
receive Warning severity level alerts for System alert types. You can manage alert recipients via the
System Administration > Alerts page in the GUI (or via the
alertconfig
command in the CLI).
To enable TLS connection alerts, click Edit Global Settings on the Destination Controls page or
destconfig -> setup
subcommand. This is a global setting, not a per-domain setting. For information
on the messages that the appliance attempted to deliver, use the Monitor > Message Tracking page or the
mail logs.
mail logs.
You must specify a certificate to use for all outgoing TLS connections. Use the Edit Global Settings on
the Destination Controls page or
the Destination Controls page or
destconfig -> setup
subcommand to specify the certificate. For
information on obtaining a certificate, see
.
For more information on alerts, see the “System Administration” chapter.
Apply Limits
Specifies whether the limit will be applied (enforces) to the entire domain or to each
mail exchange IP address specified for that domain. (Many domains have multiple MX
records.)
mail exchange IP address specified for that domain. (Many domains have multiple MX
records.)
This setting applies to connection, message, and recipient limits.
Specifies whether the limit will be applied system-wide or for each Virtual Gateway
address.
address.
Note
If you have configured groups of IP addresses, but you have not configured
virtual gateways, do not configure apply limits per each virtual gateway. This
setting is intended only for systems configured to use virtual gateways. For
information on configuring virtual gateways, see
virtual gateways, do not configure apply limits per each virtual gateway. This
setting is intended only for systems configured to use virtual gateways. For
information on configuring virtual gateways, see
.
Table 24-8
Values in the Destination Controls Table (continued)
Field
Description