Cisco Cisco ASA 5515-X Adaptive Security Appliance Notas de publicación

The following table lists the supported ASA models.

Cisco ASA Device Package Software supports only the version of APIC that it is shipped with.

This release includes support for the following:

A new command is now available which enables you to add remarks or comments about entries in 
any access list, including extended, EtherType, IPv6, standard, and Webtype access lists. This 
command is used in the same way as the access-list list_name remark text command is used for the 
ASA. For more information about how to use the command, see the 

In addition to being able to perform application-inspections on service connectors, you can now 
perform global application-inspections with the policy-map command. This command is used in the 
same way as the factory default global policy configuration on the ASA. For more information, see 
the

 Cisco Security Appliance Command Line Configuration Guide

.

A new command is now available which enables you to either:

Allow communication between interfaces with equal security levels (inter-interface)

Allow traffic to enter and exit the same interface (intra-interface)

This command is used in the same way as the same-security-traffic command is used for the ASA. 
For more information about how to use the command, see the 

.

A new command is now available which enables you to define the period of time which can be used 
in a AccessControlEntry to specify when it is active. This command is used in the same way as the 
time-range command is used for the ASA. For more information about how to use the command, 
see the 

ASA 5500-X (5512 through 5555)

ASA software Version 8.4(x) and later

ASA 5585-X 

(SSP 10 through SSP 60) 

Firepower 9300

ASA software Version 9.6(1) and later

Firepower 41xx

ASAv 

See the “ASA and ASDM Compatibility” 
section of the 

.