Cisco Cisco Firepower 4110 Security Appliance
4.
Select the rows with the required templates (using standard Windows key combinations).
5.
Select Send to Devices.
6.
Configure the parameters, and then click Submit.
Table 103: Send to Devices: Select Devices to Update Parameters
Parameter
Description
Available Devices
The DefensePro devices that you can select to update. Select devices and use
the arrows to move them to the other list as required.
Note:
The list can contain only the devices that support the
templates features.
Selected Devices
The DefensePro devices selected to update. Select devices and use the
arrows to move them to the other list as required.
Update Method
Values:
•
Append to Existing Configuration—The template adds the policy and profile
configurations, and any baselines, to the devices in the Selected Devices
list. If a policy or profile name exists in a target device, the update fails.
•
Overwrite Existing Configuration —The template adds the policy and profile
configurations, and any baselines, to the devices in the Selected Devices
list. If a policy or profile with the same name exists in a target device, the
template overwrites it.
Default: Overwrite Existing Configuration
Install on Instance
(This parameter is relevant
(This parameter is relevant
only for DefensePro x420
platforms.)
The identifier or the DefensePro hardware instance onto which to add the
template.
Values: 0, 1
Default: 0
Values: 0, 1
Default: 0
Update Policies After
Sending Configuration
Values:
•
Enabled—After successfully uploading a template to a device, an Update
Policies (activate latest changes) action is automatically initiated.
•
Disabled—After successfully uploading a template to a device, an Update
Policies (activate latest changes) action is required for the configuration to
take effect.
Default: Disabled
To delete templates and associated configuration objects from DefensePro devices
1.
Click the Toolbox (
) button.
2.
Click the Advanced (
) button to open the DefensePro Configuration Templates pane.
3.
Configure the filter as necessary (see the procedure
4.
Select the rows with the required templates (using standard Windows key combinations).
5.
Select Delete from Devices.
6.
Configure the parameters, and then click Submit.
© 2016 Cisco | Radware. All rights reserved. This document is Cisco Public.
Page 156 of 281