Cisco Cisco Firepower 4110 Security Appliance
To clean an Authentication Table for a selected DefensePro device
1.
In the Monitoring perspective, select Operational Status > Resource Utilization >
Authentication Tables
.
2.
In the relevant tab (that is, TCP Authentication Table, HTTP Authentication Table, or DNS Authentication
Table
), click Clean Table.
Note:
For the TCP Authentication Table and the HTTP Authentication Table, the Clean Table
action can take up to 10 seconds.
Monitoring DME Utilization According to Configured Policies
The contents of this tab are irrelevant for Radware DefensePro DDoS Mitigation.
Monitoring DefensePro Syslog Information
You can view information relating to the syslog mechanism.
To monitor DefensePro syslog information
>
In the Monitoring perspective, select Operational Status > Resource Utilization > Syslog Monitor.
Table 131: DefensePro Syslog Monitoring Parameters
Parameter
Description
Syslog Server
The name of the syslog server.
Status
The status of the syslog server.
Values:
Values:
•
Reachable—The server is reachable.
•
Unreachable—The server is unreachable.
•
N/R—Specifies not relevant, because traffic towards the Syslog
server is over UDP—as specified (Configuration perspective, Setup
> Syslog Server > Protocol > UDP
> Syslog Server > Protocol > UDP
).
Messages in Backlog
The number of messages in the backlog to the syslog server.
Monitoring Cisco Security Group Tags (SGTs)
You can monitor the name and value of the enabled SGT, if one exists.
Note:
For more information on SGTs in Radware DefensePro DDoS Mitigation, see
Configuring SGT Classes,
page 117
.
© 2016 Cisco | Radware. All rights reserved. This document is Cisco Public.
Page 179 of 281