Cisco Cisco ASA 5506H-X with FirePOWER Services Guía De Instalación
Cisco Firepower Threat Defense for the ASA 5506-X Series Using Firepower Management Center Quick Start Guide
6. Configure the Device for Firepower Management
5
6. Configure the Device for Firepower Management
The first time you access the CLI, a setup wizard prompts you for basic network configuration parameters that are
required to setup your Firepower Threat Defense device and to register with a Firepower Management Center.
Note that the management IP address and associated gateway route are not included on the Firepower
Management Center web interface in the list of interfaces or static routes for the device; they can only be set by
the setup script and at the CLI.
required to setup your Firepower Threat Defense device and to register with a Firepower Management Center.
Note that the management IP address and associated gateway route are not included on the Firepower
Management Center web interface in the list of interfaces or static routes for the device; they can only be set by
the setup script and at the CLI.
Before You Begin
Ensure that you connect a data interface to your gateway device, for example, a cable modem or router. For edge
deployments, this would be your Internet-facing gateway. For data center deployments, this would be a back-bone
router.
deployments, this would be your Internet-facing gateway. For data center deployments, this would be a back-bone
router.
The Management interface must also be connected to a gateway through which the Internet is accessible. System
licensing and database updates require Internet access.
licensing and database updates require Internet access.
Procedure
1.
Connect to the device, either from the console port or using SSH, for example.
—
For a device attached to a monitor and keyboard, log in at the console.
—
For access to the management interface of the device, SSH to the Management interface’s default IPv4
address: 192.168.45.45.
address: 192.168.45.45.
2.
Log in with the username admin and the password Admin123.
3.
Complete the system configuration as prompted.
You must first read and accept the end user license agreement (EULA). Then change the admin password,
then configure the management address and DNS settings, as prompted. You can configure both IPv4 and
IPv6 management addresses.
then configure the management address and DNS settings, as prompted. You can configure both IPv4 and
IPv6 management addresses.
For example:
System initialization in progress. Please stand by.
You must change the password for 'admin' to continue.
Enter new password: <new password>
Confirm new password: <repeat password>
You must configure the network to continue.
You must configure at least one of IPv4 or IPv6.
Do you want to configure IPv4? (y/n) [y]: y
Do you want to configure IPv6? (y/n) [n]:
Configure IPv4 via DHCP or manually? (dhcp/manual) [manual]:
Enter an IPv4 address for the management interface [192.168.45.45]: 10.133.128.47
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.248.0
Enter the IPv4 default gateway for the management interface []: 10.133.128.1
Enter a fully qualified hostname for this system [firepower]: laurel.example.com
Enter a comma-separated list of DNS servers or 'none' []: 10.33.16.6
Enter a comma-separated list of search domains or 'none' []:
If your networking information has changed, you will need to reconnect.
For HTTP Proxy configuration, run 'configure network http-proxy'
Manage the device locally? (yes/no) [yes]: no
4.
Reconnect to your appliance using the new log in credentials.
5.
Configure the firewall mode. For example:
Configure firewall mode? (routed/transparent) [routed]