Cisco Cisco 1900 2900 3900 Series 4-Port Gigabit Ethernet HS-WIC with PoE Guía De Instalación

Descargar
Página de 129
• Cellular networks have higher latency compared to wired networks. Latency rates depend on the
technology and carrier. Latency may be higher because of network congestion. Latency also depends
on the signal conditions and can be higher because of network congestion.
• Any restrictions that are part of the terms of service from your carrier.
• SMS—Only one text message up to 160 characters to one recipient at a time is supported. Larger texts
are automatically truncated to the proper size before being sent.
• For the router that runs the SNMP agent, you must configure appropriate access control (for example,
SNMP-server community) using the Cisco IOS CLI for the NMS and agent to work properly.
• It is strongly recommended that you configure SNMP V3 with authentication/privacy when implementing
SNMP SET operation.
Information about Configuring Cisco 4G LTE
Overview of Cisco 4G LTE
Cisco EHWIC-4G-LTEs are single-wide Wireless WAN (WWAN) EHWICs supported on Cisco 1900 Series,
2900 Series, and 3900 Series Integrated Services Router Generation 2 (ISR G2) routers. Cisco EHWIC-4G-LTEs
operate over Fourth-Generation Long-Term Evolution (4G LTE) cellular networks and Third-Generation
(3G) cellular networks. The Cisco 4G LTE WWAN EHWIC offers a highly secure, simplified, and cost-effective
WAN alternative to DSL or Frame Relay. In areas where terrestrial broadband services (cable, DSL, or T1)
are not available or are expensive, 4G LTE WWAN connectivity can be a viable alternative. Using the
integrated services available on the Cisco ISR G2 routers, Cisco 4G LTE Wireless WAN EHWICs can provide
instant and mobile communications during disasters and service outages.
Cisco 819 Series 4G LTE ISRs, Cisco C880 Series 4G LTE ISRs, and Cisco C890 Series 4G LTE ISRs also
support integrated 4G LTE wireless WAN.
Cisco 4G LTE EHWICs and Cisco 800 Series 4G LTE ISRs support the following 4G/3G modes:
• 4G LTE—4G LTE mobile specification provides multi-megabit bandwidth, more efficient radio network,
latency reduction, and improved mobility. LTE solutions target new cellular networks. These networks
initially support up to 100 Mb/s peak rates in the downlink and up to 50 Mb/s peak rates in the uplink.
The throughput of these networks is higher than the existing 3G networks
• 3G Evolution High-Speed Packet Access (HSPA/HSPA+)—HSPA is a UMTS-based 3G network. It
supports High-Speed Downlink Packet Access (HSDPA) and High-Speed Uplink Packet Access (HSUPA)
data for improved download and upload speeds. Evolution High-Speed Packet Access (HSPA+) supports
Multiple Input/Multiple Output (MIMO) antenna capability.
• 3G Evolution-Data Optimized (EVDO or DOrA) Mode—EVDO is a 3G telecommunications standard
for the wireless transmission of data through radio signals, typically for broadband Internet access. DOrA
refers to EVDO Rev-A. EVDO uses multiplexing techniques including Code Division Multiple Access
(CDMA), as well as Time Division Multiple Access (TDMA), to maximize both individual users'
throughput and the overall system throughput.
The following table describes the Cisco 4G WWAN EHWIC product SKUs.
   Cisco 4G LTE Software Configuration Guide
2
Cisco 4G LTE Software Configuration
Information about Configuring Cisco 4G LTE