Cisco Cisco ONS 15310-MA SONET Multiservice Platform Referencia técnica

This section lists the basic commands to help you get started. You must be connected and logged into 
aTL1 session. After you issue a command, confirm you receive a COMPLD response to indicate the 
command was completed successfully. 

If you receive a DENY response, first check the syntax you entered for accuracy. If you entered 
the command correctly, refer to the Cisco ONS 15454 SDH, Cisco ONS 15600 SDH, and 
Cisco ONS 15310-MA SDH TL1 Command Guide for more information about that 
particular command and its components.

To perform an in-service optical card upgrade or downgrade on a system, see 

To delete a card from the NE, see 

To change configuration information on an E1 port, see 

To enter the card type and attributes for a given slot on an NE, see 

To initialize the specified card and its associated subsystem(s), see

To remove an equipment from the In Serv.ice state and place it into Maintenance, see 

To provision an equipment into the In Service state from the Maintenance state, see 

To retrieve configuration information about an E1 port, see 

.

To retrieve all alarms on a specific E1 port, see 

To retrieve all conditions on a specific E1 port, see 

To retrieve all alarms on a system, see 

To retrieve all conditions on a system, see 

.

To retrieve all data, state, and shelf parameters on an associated equipment unit, see 

To retrieve all general attributes on a system, see 

.

To retrieve actual PM values on an E1 port, see 

.

To retrieve the thresholds in place for an E1 port, see 

To create a loopback, see 

.

To release a loopback, see