Cisco Cisco ONS 15310-MA SONET Multiservice Platform Referencia técnica

This section lists ten basic commands to help you get started. You must be connected and logged into 
a TL1 session. After you issue a command, confirm you receive a COMPLD response to indicate the 
command was completed successfully. 

If you receive a DENY response, first check the syntax you entered for accuracy. If you entered 
the command correctly, refer to the Cisco ONS 15454 and Cisco ONS 15327 TL1 Command 
Guide for more information about that particular command and its components.

To change configuration information on a DS1 port see ED-T1, page 14

To retrieve configuration information about a DS1 port see RTRV-T1, page 14

To retrieve all alarms on a specific DS1 port see RTRV-ALM-T1, page 15

To retrieve all conditions on a specific DS1 port see RTRV-COND-T1, page 16

To retrieve all alarms on a system see RTRV-ALM-ALL, page 17

To retrieve all conditions on a system see RTRV-COND-ALL, page 18

To retrieve actual PM values on a DS1 port see RTRV-PM-T1, page 19

To retrieve the thresholds in place for a DS1 port see RTRV-TH-T1, page 21

To create a loopback see OPR-LPBK-T1, page 22

To release a loopback see RLS-LPBK-T1, page 22

When you are finished using TL1 remember to log out. Follow the steps in the “Log Out of 
TL1” section on page 23 to log out.

For complete TL1 documentation, refer to the Cisco ONS 15454 and Cisco ONS 15327 TL1 
Command Guide. For a command quick reference guide, refer to the Cisco ONS 15454 and Cisco 
ONS 15327 TL1 Command Quick Reference Guide.