Cisco Cisco ONS 15310-MA SONET Multiservice Platform Referencia técnica
7
The following list shows standard responses:
COMPLD—Completed
DENY—TL1 command failed
PRTL—Partially successful response. The requested action can be completed for some of the
specified AIDs but not for all of them.
specified AIDs but not for all of them.
RTRV—The response is successful but is lengthy and is being returned in multiple parts. Each
part has a RTRV response code, but the final response has a COMPLD response code.
part has a RTRV response code, but the final response has a COMPLD response code.
d.
Response acknowledgment—Responses may also include intermediate acknowledgment
messages. Brief messages that update the user as to the status of a given command are called
acknowledgments. When a command has been sent to the NE and the NE will take longer than
two seconds to respond, the NE sends an acknowledgment message to be followed later by
the full response. The Cisco ONS 15454 and Cisco ONS 15327 support only the IP response.
messages. Brief messages that update the user as to the status of a given command are called
acknowledgments. When a command has been sent to the NE and the NE will take longer than
two seconds to respond, the NE sends an acknowledgment message to be followed later by
the full response. The Cisco ONS 15454 and Cisco ONS 15327 support only the IP response.
Example: IP 123
>
The following list shows standard acknowledgment codes:
IP—In progress
2.
Autonomous events—These are events, alarmed or otherwise, that are generated by the NE as a
result of a condition in the NE, such as an alarm condition, a change in status, or a change in the
information in the database.
result of a condition in the NE, such as an alarm condition, a change in status, or a change in the
information in the database.
Example: REPT-ALM
For information on specific command and autonomous message syntax, refer to the Cisco ONS
15454 and Cisco ONS 15327 TL1 Command Guide.
15454 and Cisco ONS 15327 TL1 Command Guide.
7
Connect to TL1
The first step in using TL1 is to connect to TL1. You only have to connect to TL1 one time per session.
A session is a related set of communication transactions between two or more network devices. There
are three ways to connect to TL1: via CTC, telnet, or craft interface. Perform one of the following
procedures to connect to TL1.
A session is a related set of communication transactions between two or more network devices. There
are three ways to connect to TL1: via CTC, telnet, or craft interface. Perform one of the following
procedures to connect to TL1.