Cisco Cisco Catalyst 6500 Series Wireless LAN Services Module (WLSM) Notas de publicación
5
Release Notes for Catalyst 6500 Series Switch and Cisco 7600 Series Wireless LAN Services Module Software Release 2.3.2
OL-6097-10
Features in Software Release 1.2
•
Local Authentication Server—The WLSM can authenticate up to 50 wireless client devices using
LEAP, EAP-FAST, or MAC-based authentication, and perform up to 5 authentications per second.
LEAP, EAP-FAST, or MAC-based authentication, and perform up to 5 authentications per second.
Features in Software Release 1.2
This section describes the features available in wireless LAN software release 1.2:
•
Hardware platforms: Cisco Aironet 1130 series access points
•
Support for the VLAN by name feature on the access points
Features in Software Release 1.1
This section describes the features available in wireless LAN software release 1.1:
•
Hardware platforms: Cisco Aironet 1100 or 1200 series access points
•
Fast, uninterrupted, secure Layer 2 and Layer 3 wireless mobility
•
Seamless Layer 3 roaming across subnets
•
Radio-management aggregation
•
Support for stateful switchover (SSO) with a redundant Supervisor Engine 720
•
Wireless domain services (WDS) scalability
–
300 access points
–
6000 users
–
16 different mobility groups (wireless network IDs) per access point
–
Sustained roaming rate of 20 roams per second for wireless LAN clients
–
Burst roaming rate of 100 roams per second for wireless LAN clients
Limitations and Restrictions
This section describes general limitations and restrictions:
•
In software release 1.1.1 through 1.4.1, you can install one WLSM in a chassis.
•
In software release 2.1.1, you can install two WLSMs, which requires Cisco IOS Release
12.2(18)SXF2.
12.2(18)SXF2.
•
You cannot configure wireless clients in the same subnet as wired clients.
•
You cannot map multiple SSIDs to a single network ID.
•
You cannot configure QoS on tunnel interfaces in systems with a PFC3A. There is full QoS support
in systems with a PFC3B or PFC3BXL.
in systems with a PFC3B or PFC3BXL.
•
If you upgrade your Supervisor 720 to Cisco IOS Release 12.2(18)SFX2, you must be running Cisco
Wireless LAN Services Module software version 1.4.3 or greater on your WLSM.
Wireless LAN Services Module software version 1.4.3 or greater on your WLSM.