Cisco Cisco ONS 15310-CL SONET Multiservice Platform Notas de publicación

Performing hard reset of CTX card may impact traffic.

Hard reset the CTX card in the pre-Cisco ONS Release 8.0 software when the FREQ OOB alarm is 
raised.

Performing hard reset of CTX may impact traffic.

Configure Cisco ONS Release 8.0 software as protect and perform the following steps:

Provision the timing references in pre-Cisco ONS Release 8.0 software.

Activate the Cisco ONS Release 8.0 software.

Downgrade to pre-Cisco ONS Release 8.0 software after the timing references are normal.

This issue will be resolved in a future release.

Wrong EXPTRC set for STS-2-1-1. There is no workaround for this issue. This issue will be resolved in 
a future release.

This section documents TL1 caveats for Release 8.5.1.

To be compatible with TL1 and DNS, all nodes must have valid names. Node names should contain 
alphanumeric characters or hyphens, but no special characters or spaces. 

This section documents caveats resolved in Release 8.5.1.

This section documents resolved Maintenance and Administration caveats for Release 8.5.1.

VxWorks is intended for qualified Cisco personnel only. Use of VxWorks by customers is not 
recommended, nor is it supported by Cisco's Technical Assistance Center. Inappropriate use of VxWorks 
commands can have a negative and service affecting impact on your network. Please consult the 
troubleshooting guide for your release and platform for appropriate troubleshooting procedures. To exit 
without logging in, enter a Control-D (hold down the Control and D keys at the same time) at the 
Username prompt. To exit after logging in, type “logout” at the VxWorks shell prompt.