Cisco Cisco MeetingTime Guía De Instalación Rápida
Configuring Call Control for Cisco Unified MeetingPlace
How to Configure Call Control for Voice Conferencing
6
Step 6
Configure all other required fields appropriately for your current deployment.
Tip
For field descriptions, select Help > This Page.
Step 7
Select Save.
Step 8
Select OK to any pop-up dialog box messages that you see.
Step 9
Repeat this procedure as necessary to route calls to each access phone number and DID number for your
Cisco Unified MeetingPlace system.
Cisco Unified MeetingPlace system.
Related Topics
•
in the
module
•
module
•
module
What to Do Next
If you are using Cisco Unified Communications Manager 6.1 or a later release to provide front-end
signaling for Cisco Unified MeetingPlace, then proceed to one of the following sections:
signaling for Cisco Unified MeetingPlace, then proceed to one of the following sections:
•
•
Otherwise, proceed to the
.
Table 2
Fields for Adding a Route Pattern in Cisco Unified Communications Manager 6.x or a Later Release
Field
Action
Route Pattern
Enter the Cisco Unified MeetingPlace phone number.
Requirements:
•
This number must not conflict with any other route pattern defined in this
Cisco Unified Communications Manager cluster.
Cisco Unified Communications Manager cluster.
•
Do not enter any spaces in this field.
Gateway/Route List
Select the
Device Name
of the SIP trunk to Cisco Unified MeetingPlace.
Call Classification
Select OnNet.
Provide Outside Dial Tone
Uncheck the check box.