Cisco Cisco Prisma II EDR Receiver Guía De Instalación
Appendix A
Module Parameter Descriptions
Module Parameter Descriptions
154
Parameter
Name (LCI)
Name (LCI)
ICIM
Abbreviation
Abbreviation
Description
Values
Default
Rx Mode
1
RxMode
1
Sets the receiver operating mode
2.5GHz or 5GHz.
Note: Changing the Rx Mode forces
the FPGA to be reprogrammed.
This takes about 10 seconds, so user
may notice a delay before the
change takes effect.
2.5GHz or 5GHz.
Note: Changing the Rx Mode forces
the FPGA to be reprogrammed.
This takes about 10 seconds, so user
may notice a delay before the
change takes effect.
0: 5GHz
1: 2.5GHz
1: 2.5GHz
5GHz
RF Ports
RxPorts
Sets whether the RF output is gated
to both connectors or just the top
connector. Refer to block diagrams
in page 36.
to both connectors or just the top
connector. Refer to block diagrams
in page 36.
1
2
2
1
Node Select
NodeSel
Selects the node to be monitored
(Node 1 to Node 4)
(Node 1 to Node 4)
1: Node 1
2: Node 2
3: Node 3
4: Node 4
2: Node 2
3: Node 3
4: Node 4
1
Note: All parameters below this point in the table relate to the attached node and are monitor-only.
Node
Temperature
Temperature
NodeTemp
Indicates the temperature of the
node interior
node interior
degC
N/A
PS 24V
Node+24V
Indicates the actual voltage on the
+24V rail of the node power supply
bus.
+24V rail of the node power supply
bus.
V
N/A
PS 7V
Node+7V
Indicates the actual voltage on the
+7V rail of the node power supply
bus.
+7V rail of the node power supply
bus.
V
N/A
PS AC
NodeAC
Indicates the AC voltage at the
node AC power input.
node AC power input.
V
N/A
Forward Mode
NdFwdMod
Sets the forward mode for the node.
In Redundant mode, the node
automatically selects between one
of two forward receivers, FRx1 or
FRx2.
In Segmented or Single mode, only
one receiver (determined during
node setup) will be active and
selected.
In Redundant mode, the node
automatically selects between one
of two forward receivers, FRx1 or
FRx2.
In Segmented or Single mode, only
one receiver (determined during
node setup) will be active and
selected.
0: Segmented
1: Redundant
2: Single
1: Redundant
2: Single
N/A