APC NetShelter ES Enclosure 40U AR500 Manual De Usuario
Los códigos de productos
AR500
7
Stabilizing the Enclosure
Warning
To avoid tipping damage or personal injury, move the
enclosure to its permanent location and level it before you
load equipment.
enclosure to its permanent location and level it before you
load equipment.
Leveling feet
Leveling feet are attached under the enclosure at each corner.
They provide a stable base if the selected floor space is uneven
but are not intended to compensate for a badly sloped surface.
They provide a stable base if the selected floor space is uneven
but are not intended to compensate for a badly sloped surface.
Leveling
procedure
1. Move the enclosure to a relatively level location.
2. Fit the 14 mm open-end wrench (included) to the hex nut
2. Fit the 14 mm open-end wrench (included) to the hex nut
just above the round pad on the bottom of a leveling foot.
Turn the wrench clockwise to extend the leveling foot until
it makes firm contact with the floor surface.
Turn the wrench clockwise to extend the leveling foot until
it makes firm contact with the floor surface.
3. Repeat step 2 for each of the remaining leveling feet.
4. Use a spirit level to determine which feet need further
4. Use a spirit level to determine which feet need further
adjustment to level the enclosure. Adjust as necessary.
Stabilizer Plate
Kit
APC offers a Stabilizer Plate (AR8115) for attaching to the
enclosure frame with 8 mm socket head cap screws. The plate
may also be bolted to the floor to add stability.
enclosure frame with 8 mm socket head cap screws. The plate
may also be bolted to the floor to add stability.