Cisco Headend System Release 2.7 Notas de publicación
Chapter 3 System Release 2.7/3.7/4.2 SP2 Installation Procedures
96
4019475 Rev D
Configuring Secondary BFS QAMs on an SDV
System (Optional)
System (Optional)
Introduction
If you are currently utilizing Distributed BFS and you are upgrading your system to
support SDV, the system automatically adds sources 24 through 32 and
automatically disables any newly created sources. Any existing sources will be
disabled. These additional sources will need to be added to all of your secondary
BFS QAMs.
support SDV, the system automatically adds sources 24 through 32 and
automatically disables any newly created sources. Any existing sources will be
disabled. These additional sources will need to be added to all of your secondary
BFS QAMs.
Note: If your site does not support the SDV option, you may skip the procedures in
this section.
this section.
This section provides procedures for sites using either a BFS BIG or a Direct ASI
model. Choose the procedure that pertains to your system.
model. Choose the procedure that pertains to your system.
Adding BFS Sources - Sites Using a BFS BIG
Complete the following procedure if your DNCS uses a BFS BIG to distribute the
BFS carousel data.
1 Open the Set Up BIG window by following the quick path:
BFS carousel data.
1 Open the Set Up BIG window by following the quick path:
DNCS Administrative Console > Network Element Provisioning tab > BIG >
File > Open
File > Open
2 Click PAT Configuration to open the BIG PAT window.
3 Verify the BIG PAT Session Number and Program Number data, making sure
3 Verify the BIG PAT Session Number and Program Number data, making sure
that your Program Numbers are sequentially in order and in line with the
Session Numbers.
Note: Your DNCS sessions 2 through 22 should not change; however, DNCS
sessions greater than 22 must be deleted and reentered with the correct
sequential Program Number.
Example: BIG PAT Session Number and Program Number Data (Program
Numbers in Sequential Order and in line with Session Numbers)
Session Numbers.
Note: Your DNCS sessions 2 through 22 should not change; however, DNCS
sessions greater than 22 must be deleted and reentered with the correct
sequential Program Number.
Example: BIG PAT Session Number and Program Number Data (Program
Numbers in Sequential Order and in line with Session Numbers)
Session Number
Program Number
2
128
4
129
6
130
8
131
10
132
12
133