Cisco Cisco D9824 Advanced Multi Decryption Receiver Guía De Instalación
Chapter 5 Web GUI Setup and Monitoring
168
78-4039426-01 Rev D
Configuring the DPM ASI Details
The following procedure defines all the available fields. For a typical setup of the
DPM, see Typical set up for Digital Program Mapping (DPM) (on page 182).
DPM, see Typical set up for Digital Program Mapping (DPM) (on page 182).
Note: After you make any changes, a successfully updated (session open) message
appears. The changes are displayed, but not saved. You must click Apply to save
and apply the changes.
1 From the user interface of the D9824, click Transport Stream > Transport
appears. The changes are displayed, but not saved. You must click Apply to save
and apply the changes.
1 From the user interface of the D9824, click Transport Stream > Transport
Handling, expand ASI Output and then click Digital Program Mapping. The
Digital Program Mapping page is displayed.
Digital Program Mapping page is displayed.
2 For each DPM Program Entry, it displays the input channel number (Chl #) and
channel Name, whether the PE is passed, dropped, or mapped (Action), the
output channel (Output Ch#), and the PMT PID (PMT PID).
Note: Any changes made to the DPM Program Entry Setup configuration
automatically changes the Output Mode to Full DPM Control in the ASI Output
page.
output channel (Output Ch#), and the PMT PID (PMT PID).
Note: Any changes made to the DPM Program Entry Setup configuration
automatically changes the Output Mode to Full DPM Control in the ASI Output
page.
3 Select the program entry you want to edit.
4 The Action is automatically updated when you select the Output Mode in the
4 The Action is automatically updated when you select the Output Mode in the
ASI Output page. For more information, see Configuring the ASI Output (on
page 165). You can optionally select the DPM program action for the PE (Pass,
Map, or Drop) in the Action drop-down list.
Note: If the PE is mapped, it uses the last valid input. The output map (for
example, output channel PMT) does not change automatically if the input or
channel number is changed.
page 165). You can optionally select the DPM program action for the PE (Pass,
Map, or Drop) in the Action drop-down list.
Note: If the PE is mapped, it uses the last valid input. The output map (for
example, output channel PMT) does not change automatically if the input or
channel number is changed.