Cisco Cisco D9824 Advanced Multi Decryption Receiver Guía De Instalación
Configuring System Settings
78-4039426-01 Rev D
187
Setting up IP Information
1 From the user interface of the D9824, click System Settings > System > IP
Settings. The IP Settings page is displayed.
2 In the top section, you can set the parameters for communicating with other
equipment via the Ethernet Data and Management ports for IP applications and
upgrading application software.
upgrading application software.
3 Select control or data1 settings and set the IPv4 Destination IP Address for the
interface. The address is 12 digits in length (###.###.###.###).
4 Set the number of CIDR (Classless Inter-Domain Routing) bits in the network
Mask (8 to 30).
5 Set the Gateway Address on the Network, used to expose the receiver to a WAN.
The IP Address, IP Mask, and Gateway Address should be changed together, i.e.,
as a group. The following table shows the most commonly used Subnet mask
values to enter for a chosen IP address mask, which will depend on the size of
your network.
as a group. The following table shows the most commonly used Subnet mask
values to enter for a chosen IP address mask, which will depend on the size of
your network.
Mask
Subnet Mask
8
255.0.0.0
16
255.255.0.0
24
255.255.255.0
6 Select the speed and duplex type of the interface (PHY Mode). Select Auto for
PHY to negotiate speed and duplex with other devices on the network, or select
10 HD (half-duplex), 10 FD (full-duplex), 100 HD, 100 FD, or 1000 FD to lock into
a fixed mode. The default is Auto.
10 HD (half-duplex), 10 FD (full-duplex), 100 HD, 100 FD, or 1000 FD to lock into
a fixed mode. The default is Auto.