Cisco Cisco Aironet 1200 Access Point Guía De Instalación
22
78-16238-04
Connecting to an Ethernet Network with Local
Power
Power
Follow these steps to connect the access point to an Ethernet LAN when you
have a local power source:
have a local power source:
1.
Connect the Ethernet cable to the RJ-45 Ethernet connector labeled
Ethernet on the access point.
Ethernet on the access point.
Caution
Both the Ethernet and console ports use RJ-45 connectors.
Make sure that you connect the Ethernet cable to the Ethernet
port and not to the console port.
Make sure that you connect the Ethernet cable to the Ethernet
port and not to the console port.
2.
Connect the power pack’s power output connector to the 48-VDC power
port labeled 48VDC on the access point.
port labeled 48VDC on the access point.
3.
Plug the other end of the power pack into an approved 100 to 240 VAC
outlet.
outlet.
Powering Up the Access Point
When power is applied to the access point, it begins a routine power-up
sequence that you can monitor by observing the three LEDs on top of the
access point. All three LEDs on the top of the access point (Radio, Status, and
sequence that you can monitor by observing the three LEDs on top of the
access point. All three LEDs on the top of the access point (Radio, Status, and