Cisco Cisco Aironet 3500p Access Point Guía De Instalación

This equipment operates on a secondary basis and consequently must accept harmful interference, 
including interference from stations of the same kind. This equipment may not cause harmful 
interference to systems operating on a primary basis. 

All the Declaration of Conformity statements related to this product can be found at the following 
location: 

This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP 
server for use with Cisco Aironet lightweight access points. For other DHCP server implementations, 
consult product documentation for configuring DHCP Option 43. In Option 43, you should use the 
IP address of the controller management interface.

DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a 
separate DHCP pool for each access point type.

The 3500 series access point uses the type-length-value (TLV) format for DHCP Option 43. DHCP 
servers must be programmed to return the option based on the access point’s DHCP Vendor Class 
Identifier (VCI) string (DHCP Option 60). The VCI string for the 3500 series access point is:

If your access point was ordered with the Service Provider Option (AIR-OPT60-DHCP) 
selected in the ordering tool, the VCI string for the access point contains ServiceProvider. For 
example, an AP3500 with this option will return this VCI string: 
Cisco AP c3500-ServiceProvider

The format of the TLV block is listed below: 

Type: 0xf1 (decimal 241) 

Length: Number of controller IP addresses * 4 

Value: List of WLC management interfaces 

To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps: