Cisco Cisco Web Security Appliance S170 Notas de publicación
3
Cisco Update for RAID Controller Firmware (For S360/S370/S660/S670 only, reboot required)
Support
Note
After you run the firmware upgrade, the firmware upgrade package will display in the list of available
upgrades even after a successful installation. The presence of this package does not indicate a failed
upgrade.
upgrades even after a successful installation. The presence of this package does not indicate a failed
upgrade.
Step 8
To verify that the upgrade has run successfully, you can run the upgrade script again after the machine
has rebooted. If the upgrade was successful, the upgrade script will indicate that the appliance does not
require upgrading.
has rebooted. If the upgrade was successful, the upgrade script will indicate that the appliance does not
require upgrading.
Accessing the CLI
To run this upgrade, you must access the CLI. The instructions below provide information on accessing
the CLI.
the CLI.
Access to the CLI varies depending on the management connection method chosen while setting up the
appliance. Initially, only the admin user account has access to the CLI. You can add other users with
differing levels of permission after you have accessed the command line interface for the first time via
the admin account. The system setup wizard asks you to change the password for the admin account. The
password for the admin account can also be reset directly at any time using the password command. To
connect via Ethernet: Start an SSH or Telnet session with the factory default IP address 192.168.42.42.
SSH is configured to use port 22. Telnet is configured to use port 23.
appliance. Initially, only the admin user account has access to the CLI. You can add other users with
differing levels of permission after you have accessed the command line interface for the first time via
the admin account. The system setup wizard asks you to change the password for the admin account. The
password for the admin account can also be reset directly at any time using the password command. To
connect via Ethernet: Start an SSH or Telnet session with the factory default IP address 192.168.42.42.
SSH is configured to use port 22. Telnet is configured to use port 23.
To connect via a Serial connection: Start a terminal session with the communication port on your
personal computer that the serial cable is connected to. See the “Setup and Installation” chapter in the
Cisco IronPort AsyncOS Configuration Guide for more information. Enter the user name and password
below.
personal computer that the serial cable is connected to. See the “Setup and Installation” chapter in the
Cisco IronPort AsyncOS Configuration Guide for more information. Enter the user name and password
below.
Factory Default User name and Password
• Username:
admin
• Password:
ironport
Support
Cisco Support Community
Cisco Support Community is an online forum for Cisco customers, partners, and employees. It provides
a place to discuss general web security issues as well as technical information about specific Cisco
products. You can post topics to the forum to ask questions and share information with other Cisco and
Cisco IronPort users.
a place to discuss general web security issues as well as technical information about specific Cisco
products. You can post topics to the forum to ask questions and share information with other Cisco and
Cisco IronPort users.
Access the Cisco Support Community at the following URL:
•
For web security and associated management: