Cisco Cisco Web Security Appliance S170 Guía Del Usuario
17-12
Cisco AsyncOS 8.0.6 for Web User Guide
Chapter 17 Generate Reports to Monitor End-user Activity
SNMP Monitoring
Hardware Objects
Hardware sensors conforming to the Intelligent Platform Management Interface Specification (IPMI)
report temperature, fan speed, and power supply status.
report temperature, fan speed, and power supply status.
The number displayed is the number of instances of that object that can be monitored. For example, you
can query the RPMs for 4 fans in the S350 appliance.
can query the RPMs for 4 fans in the S350 appliance.
Hardware Traps
Status change traps are sent when the status changes. Fan Failure and high temperature traps are sent
every 5 seconds. The other traps are failure condition alarm traps - they are sent once when the state
changes (healthy to failure). Temperatures within 10 per cent of the critical value may be a cause for
concern.
every 5 seconds. The other traps are failure condition alarm traps - they are sent once when the state
changes (healthy to failure). Temperatures within 10 per cent of the critical value may be a cause for
concern.
Note
Failure condition alarm traps represent a critical failure of the individual component, but may not cause
a total system failure.
a total system failure.
SNMP Traps
SNMP provides the ability to send traps, or notifications, to advise an administration application when
one or more conditions have been met. Traps are network packets that contain data relating to a
component of the system sending the trap. Traps are generated when a condition has been met on the
SNMP agent (in this case, the Cisco appliance). After the condition has been met, the SNMP agent then
forms an SNMP packet and sends it over port 162, the standard SNMP trap port. In the example below,
the trap target of
one or more conditions have been met. Traps are network packets that contain data relating to a
component of the system sending the trap. Traps are generated when a condition has been met on the
SNMP agent (in this case, the Cisco appliance). After the condition has been met, the SNMP agent then
forms an SNMP packet and sends it over port 162, the standard SNMP trap port. In the example below,
the trap target of
10.1.1.29
and the Trap Community string are entered. This is the host running the
SNMP management console software that will receive the SNMP traps from the appliance.
You can configure SNMP traps (enable or disable specific traps) when you enable SNMP for an
interface. To specify multiple trap targets: when prompted for the trap target, you may enter up to 10
comma separated IP addresses.
interface. To specify multiple trap targets: when prompted for the trap target, you may enter up to 10
comma separated IP addresses.
Model
Ambient Temp
Fans
Power Supply
Disk Status
NIC Link
S160
1
2
1
2
6
S350
1
4
2
6
6
S360
1
4
2
4
6
S650
1
4
2
6
6
S660
1
4
2
6
6
Model
High Temp
(Ambient)
(Ambient)
Fan Failure
Power Supply
RAID
Link
S160/S350/S360/S650
/S660
/S660
47C
0 RPMs
Status Change
Status Change
Status Change