Cisco Cisco Web Security Appliance S680 Guía Del Usuario
B-1
Cisco AsyncOS for Web User Guide
A P P E N D I X
B
Command Line Interface
•
Overview of the Command Line Interface, page 27-1
•
Accessing the Command Line Interface, page 27-1
•
General Purpose CLI Commands, page 27-4
•
Web Security Appliance CLI Commands, page 27-6
Overview of the Command Line Interface
The AsyncOS Command Line Interface (CLI) allows you to configure and monitor the Web Security
appliance. The Command Line Interface is accessible using SSH on IP interfaces that have been
configured with these services enabled, or using terminal emulation software on the serial port. By
default, SSH is configured on the Management port.
appliance. The Command Line Interface is accessible using SSH on IP interfaces that have been
configured with these services enabled, or using terminal emulation software on the serial port. By
default, SSH is configured on the Management port.
The commands are invoked by entering the command name with or without any arguments. If you enter
a command without arguments, the command prompts you for the required information.
a command without arguments, the command prompts you for the required information.
Accessing the Command Line Interface
You can add other users with differing levels of permission after you have accessed the CLI for the first
time using the admin account. The System Setup Wizard prompts you to change the password for the
admin account.
time using the admin account. The System Setup Wizard prompts you to change the password for the
admin account.
You can also reset the admin account password at any time using the
passwd
command.
You can connect using one of the following methods:
•
Ethernet. Start an SSH session with the IP address of the Web Security appliance. The factory
default IP address is 192.168.42.42. SSH is configured to use port 22.
default IP address is 192.168.42.42. SSH is configured to use port 22.
•
Serial connection. Start a terminal session with the communication port on your personal computer
that the serial cable is connected to.
that the serial cable is connected to.
Log in to the appliance by entering the username and password below.
•
Username:
admin
•
Password:
ironport