Cisco Cisco Web Security Appliance S190 Guía Del Usuario
Chapter 3 Deployment
Appliance Interfaces
3-4
Cisco IronPort AsyncOS 7.0 for Web User Guide
OL-23079-01
Figure 3-1
Web Security Appliance Ethernet Ports
Use the “T” ports for the L4 Traffic Monitor.
Use the “P” ports for the Web Proxy.
Use the M1 port for administering
the appliance.
the appliance.
Management Interface
Use M1 to administer the appliance. Optionally, you can also configure the M1
interface to handle Web Proxy data traffic. You might want to use the M1 interface
for data traffic if your organization does not use a separate management network.
interface to handle Web Proxy data traffic. You might want to use the M1 interface
for data traffic if your organization does not use a separate management network.
For more information about using the M1 port to set up and manage the appliance,
see
see
.
For more information about configuring the network interfaces, see
Data Interfaces
The appliance uses the Data interfaces for Web Proxy data traffic. You can enable
and use just the P1 port or both the P1 and P2 ports for data traffic.
and use just the P1 port or both the P1 and P2 ports for data traffic.
•
P1 only enabled. When only P1 is enabled, connect it to the network for both
incoming and outgoing traffic.
incoming and outgoing traffic.
•
P1 and P2 enabled. When both P1 and P2 are enabled, you must connect P1
to the internal network and P2 toward the Internet.
to the internal network and P2 toward the Internet.