Cisco Cisco Web Security Appliance S680 Guía Del Usuario
25-7
Cisco IronPort AsyncOS 7.0 for Web User Guide
OL-23079-01
Chapter 25 Configuring Network Settings
Configuring TCP/IP Traffic Routes
Configuring TCP/IP Traffic Routes
You can administer routes for data and management traffic, add static routes, load
your IP routing tables, and modify the default gateway using the Network >
Routes page or the
your IP routing tables, and modify the default gateway using the Network >
Routes page or the
routeconfig
command.
The number of sections on this page is determined by how the “Restrict M1 port
to appliance management services only” check box is configured on the Network
> Interfaces page:
to appliance management services only” check box is configured on the Network
> Interfaces page:
•
Separate route configuration sections for Management and Data traffic.
When you use the Management interface for management traffic only
(“Restrict M1 port” is enabled), then this page includes two sections to enter
route table information, one for management traffic and one for data traffic.
AsyncOS uses the management route information for management traffic
only, and data route information for data traffic.
When you use the Management interface for management traffic only
(“Restrict M1 port” is enabled), then this page includes two sections to enter
route table information, one for management traffic and one for data traffic.
AsyncOS uses the management route information for management traffic
only, and data route information for data traffic.
shows
the Routes page when the option is enabled.
•
One route configuration section for all traffic (Management and Data).
When you use the Management interface for both management and data
traffic (“Restrict M1 port” is disabled), then this page includes one section to
enter route table information for all traffic that leaves the Web Security
appliance, both management and data traffic.
When you use the Management interface for both management and data
traffic (“Restrict M1 port” is disabled), then this page includes one section to
enter route table information for all traffic that leaves the Web Security
appliance, both management and data traffic.
Note
A route gateway must reside on the same subnet as the Management or Data
interface on which it is configured.
interface on which it is configured.
Modifying the Default Route
You can modify the default gateway in the web interface or in the CLI using the
setgateway
CLI command.
Note
The Web Proxy sends out transactions on the data interface that is on the same
network as the default gateway configured for data traffic.
network as the default gateway configured for data traffic.
To modify the default gateway in the web interface: