Cisco Cisco Web Security Appliance S160 Guía Del Usuario
352
I R O N P O R T A S Y N C O S 6 . 3 F O R W E B U S E R G U I D E
Testing Authentication Settings in the CLI
You can use the
testauthconfig
CLI command to test authentication settings defined for a
given realm. The command syntax is:
testauthconfig [-d level] [realm name]
Running the command without any option causes the appliance to list the configured
authentication realms from which you can make a selection.
authentication realms from which you can make a selection.
The debug flag (
-d
) controls the level of debug information. The levels can range between
0-10. If unspecified, the appliance uses a level of 0. With level 0, the command will return
success or failure. If the test settings fail, the command will list the cause of the failure.
success or failure. If the test settings fail, the command will list the cause of the failure.
Note — IronPort recommends you use level 0. Only use a different debug level when you
need more detailed information to troubleshoot.
need more detailed information to troubleshoot.
For more information about the
testauthconfig
command, see “Web Security Appliance