Cisco Cisco Web Security Appliance S160 Guía Del Usuario
2-8
AsyncOS 9.1 for Cisco Web Security Appliances User Guide
Chapter 2 Connect, Install, and Configure
System Setup Wizard
Network / Routes for Management and Data Traffic
Note
If you enable “Use M1 port for management only”, this section will have separate sections for
management and data traffic; otherwise one joint section will be shown.
management and data traffic; otherwise one joint section will be shown.
Network / Transparent Connection Settings
Network /Administrative Settings
Property
Description
Default Gateway
The default gateway IP address to use for the traffic through the Management and
Data interfaces.
Data interfaces.
Static Routes
Table
Table
Optional static routes for management and data traffic. Multiple routes can be added.
•
Name – A name used to identify the static route.
•
Internal Network – The IPv4 address for this route’s destination on the network.
•
Internal Gateway – The gateway IPv4 address for this route. A route gateway
must reside on the same subnet as the Management or Data interface on which
it is configured.
must reside on the same subnet as the Management or Data interface on which
it is configured.
Property
Description
Layer-4 Switch or
No Device
No Device
Specifies that the Web Security appliance is connected to a layer 4 switch for
transparent redirection, or that no transparent redirection device is used and clients
will explicitly forward requests to the appliance.
transparent redirection, or that no transparent redirection device is used and clients
will explicitly forward requests to the appliance.
WCCP v2 Router
Specifies that the Web Security appliance is connected to a version 2
WCCP-capable router.
WCCP-capable router.
If you connect the appliance to a version 2 WCCP router, you must create at
least one WCCP service. You can enable the standard service on this screen, or
after the System Setup Wizard is finished, where you can also create multiple
dynamic services.
least one WCCP service. You can enable the standard service on this screen, or
after the System Setup Wizard is finished, where you can also create multiple
dynamic services.
When you enable the standard service, you can also enable router security and
enter a passphrase. The passphrase used here must be used all appliances and
WCCP routers within the same service group.
enter a passphrase. The passphrase used here must be used all appliances and
WCCP routers within the same service group.
A standard service type (also known as the “web-cache” service) is assigned a
fixed ID of zero, a fixed redirection method (by destination port), and a fixed
destination port of 80.
fixed ID of zero, a fixed redirection method (by destination port), and a fixed
destination port of 80.
A dynamic service type allows you to define a custom ID, port numbers, and
redirection and load balancing options.
redirection and load balancing options.
Property
Description
Administrator
Passphrase
Passphrase
The passphrase used to access the Web Security appliance for
administrative purposes.
administrative purposes.
Email System Alerts
To
To
The email address to which the appliance sends systems alerts.