Cisco Cisco Web Security Appliance S680 Guía Del Usuario
2-15
AsyncOS 9.1 for Cisco Web Security Appliances User Guide
Chapter 2 Connect, Install, and Configure
Using the P2 Data Interface for Web Proxy Data
Note
The shared secret, virtual IP, and failover group ID must be the same for all appliances in the failover
group.
group.
Step 10
Enter the delay in seconds (1 to 255) between hosts advertising their availability in the Advertisement
Interval field.
Interval field.
Step 11
Submit and commit your changes.
Related Topics
•
Edit High Availability Global Settings
Step 1
Choose Network > High Availability.
Step 2
In the High Availability Global Settings area, click Edit Settings.
Step 3
In the Failover Handling menu, choose an option.
•
Preemptive—The highest priority host will assume control when available.
•
Non-preemptive—The host in control will remain in control even if a higher priority host becomes
available.
available.
Step 4
Click Submit. Alternatively, click Cancel to abandon your changes.
View Status of Failover Groups
Choose Network > High Availability. The Failover Groups area displays the current fail-over group.
You can click Refresh Status to update the display. You can also view fail-over details by choosing
Network > Interfaces or Report > System Status.
You can click Refresh Status to update the display. You can also view fail-over details by choosing
Network > Interfaces or Report > System Status.
Using the P2 Data Interface for Web Proxy Data
By default, the web proxy does not listen for requests on P2, even when enabled. However, you can
configure P2 to listen for web proxy data.
configure P2 to listen for web proxy data.
Note
If you enable P2 to listen for client requests using the
advancedproxyconfig > miscellaneous
CLI
command, you can choose whether to use P1 or P2 for outgoing traffic. To use P1 for outgoing traffic,
change the Default Route for data traffic to specify the next IP address that the P1 interface is connected to.
change the Default Route for data traffic to specify the next IP address that the P1 interface is connected to.
Before You Begin
•
Enable P2 (you must also enable P1 if not already enabled) (see