Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module Guía De Instalación
5
Cisco Prime Network Analysis Module Catalyst 6500 Series Switch Installation and Configuration Guide
OL-24434-02
Cisco Catalyst 6500 Series NAM (WS-SVC-NAM3-6G-K9) Bare Metal Installation
Warning
Remember to use an ESD or antistatic wrist strap, a conductive foam pad or mat (recommended), and
follow all necessary antistatic standards when handling the hard disk drives.
follow all necessary antistatic standards when handling the hard disk drives.
Step 5
If a hard drive is already installed in the hard drive tray, you can remove it by unfastening the four screws
that attach it to the drive tray with a Number 2 Phillips screwdriver.
that attach it to the drive tray with a Number 2 Phillips screwdriver.
Step 6
Install the new DIMMs or hard drive. Avoid extra force when removing and inserting DIMMs.
Step 7
Plug the NAM-3 back in. You would see the STATUS button go red, and then green when it is booting up.
Recovery Procedure
Complete the following steps for the recovery:
Step 1
Access the switch CLI in enable mode using Telnet or SSH.
At this point you will need to set the management vlan for the Cisco Catalyst 6500 Series NAM
(WS-SVC-NAM3-6G-K9) blade correctly. The IP address used for the NAM will also be used to
download and install the recovery image from rommon. However, for connectivity to occur, the switch
will need to be set to route traffic to the Cisco Catalyst 6500 Series NAM (WS-SVC-NAM3-6G-K9)
management interface. The vlan ID in the command below must contain the IP address that must be used
for the NAM management port.
(WS-SVC-NAM3-6G-K9) blade correctly. The IP address used for the NAM will also be used to
download and install the recovery image from rommon. However, for connectivity to occur, the switch
will need to be set to route traffic to the Cisco Catalyst 6500 Series NAM (WS-SVC-NAM3-6G-K9)
management interface. The vlan ID in the command below must contain the IP address that must be used
for the NAM management port.
Replace X below with the valid module and XX with valid vlan information.
Cisco6500# conf t
Cisco6500(config)# analysis module X management-port X access-vlan XX
Cisco6500(config)#
Optionally, save the config.
Cisco6500# wr mem
Building configuration...
[OK]
Cisco6500#
Step 2
Plug the Cisco Catalyst 6500 Series NAM (WS-SVC-NAM3-6G-K9) blade into an open slot on the
switch.
switch.
Step 3
Session into the Cisco Catalyst 6500 Series NAM (WS-SVC-NAM3-6G-K9) console from your switch
session.
session.
Cisco6500#service-module session slot X
You can type Ctrl-^, then x at the remote prompt to end the session
Trying 127.0.0.20, 2065 ... Open
At this point you may see a bootup sequence on the session terminal, or a rommon prompt. You must get
to the blade's rommon prompt to start the recovery process.
to the blade's rommon prompt to start the recovery process.
Look for this output during bootup:
Break out with <ESC>