Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module
5
Cisco SM-X-1T3/E3 Enhanced Service Module Configuration Guide
OL-27148-02
Cisco SM-X-1T3/E3 Enhanced Service Module Configuration Guide
Configuring the SM-1T3/E3 Service Module
•
•
Configuring the Card Type and Controller for a T3 Interface
When the SM-X-1T3/E3 is used for the first time, the running configuration does not show the T3/E3
controller and its associated serial interface. You can use the show version command to determine
whether the router recognized the T3/E3 card and was able to initialize the card properly. After the card
type is configured for the slot, the respective controller and serial interface appear in the running
configuration. See
controller and its associated serial interface. You can use the show version command to determine
whether the router recognized the T3/E3 card and was able to initialize the card properly. After the card
type is configured for the slot, the respective controller and serial interface appear in the running
configuration. See
.
After the service module has ascertained that the card has been initialized properly, use the card type
command to configure the card. If the command is accepted successfully, Cisco IOS software creates a
controller and a serial interface for the card.
command to configure the card. If the command is accepted successfully, Cisco IOS software creates a
controller and a serial interface for the card.
Perform this task to select and configure a card type and controller as T3 on 2900 and 3900 Series ISRs:
Note
The autoconfig/setup utility does not support configuring the card type for the SM-X-1T3/E3.