Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module Guía De Instalación
5
Catalyst 6500 Series Switch SSL Services Module Installation and Verification Note
78-15947-01
Required Tools
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Statement 1030
These tools are required to install the SSL Services Module into the Catalyst 6500 series switch:
•
Flat-blade screwdriver
•
Wrist strap or other grounding device
•
Antistatic mat or antistatic foam
Installing the SSL Services Module
Note
Before installing the SSL Services Module, you must install the Catalyst 6500 series switch chassis and
at least one supervisor engine. For information on installing the switch chassis, refer to the Catalyst 6500
Series Switch Installation Guide.
at least one supervisor engine. For information on installing the switch chassis, refer to the Catalyst 6500
Series Switch Installation Guide.
This section describes how to install the SSL Services Module into the Catalyst 6500 series switch.
Note
All modules, including the supervisor engine (if you have redundant supervisor engines), support hot
swapping. You can add, replace, or remove modules without interrupting the system power or causing
other software or interfaces to shut down. For more information about hot-swapping modules, refer to
the Catalyst 6500 Series Switch Module Installation Guide.
swapping. You can add, replace, or remove modules without interrupting the system power or causing
other software or interfaces to shut down. For more information about hot-swapping modules, refer to
the Catalyst 6500 Series Switch Module Installation Guide.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
touch the backplane with your hand or any metal tool, or you could shock yourself.
To install the SSL Services Module into the Catalyst 6500 series switch, perform these steps:
Step 1
Make sure that you take the necessary precautions to prevent ESD damage.
Step 2
Choose a slot for the SSL Services Module. See
for the slot numbers on a Catalyst 6500 series
switch.