Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module Guía De Instalación

To understand the Cisco IOS command-line interface and Cisco IOS command modes, refer to 
Chapter 2, “Command-Line Interfaces,” in the Catalyst 6500 Series Switch Cisco IOS Software 
Configuration Guide. 

To understand the Catalyst operating system command-line interface and Catalyst operating system 
command modes, refer to Chapter 2, “Command-Line Interfaces,” in the Catalyst 6500 Series Switch 
Configuration Guide. 

Unless your switch is located in a fully trusted environment, we recommend that you configure the 
module through a Telnet connection using Secure Shell (SSH) encryption.

You can session into the module from the switch console to configure the CSM. The session is a Telnet 
interface through the Ethernet out-of-band channel (EOBC) of the switch backplane.

You can also make a Telnet connection into the module from a specified host and on a specific interface. 
Telnet support for this host should be configured or enabled from the module console.

Console output is redirected to all active Telnet sessions. When no Telnet session is available, the output 
is saved to a buffer. The buffer output can be subsequently examined when you make a Telnet connection 
into the module. 

Use this document with the following Cisco documents:

Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide 

Invisible laser radiation present. Statement 1016